White Knight® Crystal Clear Acrylic

310g

White Knight Crystal Clear Acrylic is a clear topcoat designed to enhance and protect your craft and DIY projects.



Features

• Clear finish

• Provides a protective coating over oil and water based paints

• Resists cracking and yellowing

• Interior and exterior application

• Adjustable aerosol spray nozzle

• Safe to spray - CFC and lead free

• Non-chroming formula

• Quick drying

• Available in a clear gloss and satin finish

White Knight Crystal Clear Acrylic can be used on interior walls, ceilings, trims, toys and accent features.

1. PREPARATION

  • Thoroughly clean the surface and ensure it is free from grease, oil, dirt, rust scale and other contaminants.
  • Sand surface with #600 grade sand paper.
  • Ensure surface is dry.
  • Cover all necessary areas to protect from overspray.

2. APPLICATION

BEFORE SPRYAING

  • Shake can vigorously for one minute to ensure product uniformity. Shake can occasionally during use.
  • Remove the cap. Avoid using sharp objects that may puncture the can.
  • Test spray on a small inconspicuous area to ensure surface compatibility and finish suitability.

SPRAYING

  • Hold the can upright approximately 20cm from the surface.
  • Press button firmly and spray with a smooth sweeping motion. Apply a pre-wetting mist coat followed by a full even coat, overlapping each spray pass. To prevent paint sagging, avoid spraying too close to the surface or spraying a heavy coat.
  • Repeat if necessary.
  • Do not use when the air or surface temperature is below 15°C or above 30°C or in excessive humidity.

3. COVERAGE

Approximately 1.5m² per can, depending on the nature of the surface and amount of overspray.

4. DRYING

Touch dry 15 minutes. Re-coat after 1 hour. Drying times will be slower in cold or humid conditions, in the absence of ventilation or where heavy film builds are applied.

5. CLEAN UP

  • Overspray can be removed while still wet with White Knight Rust Guard® Solvent or mineral turps.
  • To clean nozzle after use and prevent blocking turn the can upside down and press button until only gas escapes.

6. SAFETY & FIRST AID

KEEP OUT OF REACH OF CHILDREN.

  • If swallowed, drink plenty of water and seek medical advice immediately. Do not induce vomiting.
  • If in eyes, immediately flush with running water for at least 15 minutes. Seek immediate medical attention.
  • Avoid breathing vapour or mist.
  • Use only with adequate ventilation.
  • If on skin, remove contaminated clothing. Wash skin thoroughly with soap and water. Do not use solvents or thinners.
  • Warning - Misuse by concentrating and inhaling contents can be harmful or fatal.

For 24 hour medical emergency response in Australia call 1800 883 254 and in New Zealand call 0800 000 096

7. CAUTION

HIGHLY FLAMMABLE. Keep can away from flame and heat and eliminate any source of ignition. Keep can in a cool place and out of sun. Contents of can under pressure. Do not puncture or incinerate the can, even when empty.

8. ENVIRONMENT

  • Residual paint should be sprayed onto newspaper, allowed to dry and then disposed of via domestic waste collections.
  • Empty aerosol cans are recyclable via steel can recycling programs.
  • Important: Deliberate misuse of this product to damage public or private property is a crime.

 

 

Need Help?

It’s as easy as selecting a project type and the material involved