White Knight® Hi Temp

300g

White Knight Hi Temp is a heat resistant finish designed for use on metal surfaces subject to extreme heat.



Features

• Heat resistant to 540°C

• Durable flat finish

• Quick drying

• Silicon based

• Excellent coverage

• No primer required

• Interior and exterior use

• Adjustable spray nozzle

• Safe to spray – CFC and lead free

• Non-chroming formula

White Knight® Hi Temp is ideal for use on boilers, exhaust, manifolds, ovens and slow combustion stoves.

Not suitable for use on BBQ hot plates or food contact surfaces.

1. PREPARATION

  • Thoroughly clean the surface and ensure it is free from grease, oil, dirt, rust scale and other contaminants.
  • Lightly sand previously painted and glossy surfaces.
  • Wipe surface with mineral turps and allow to dry before painting.
  • Cover all necessary areas to protect from overspray.

2. APPLICATION

BEFORE SPRAYING

  • Shake can vigorously for 1 minute to ensure colour uniformity. Shake can occasionally during use.
  • Remove the cap carefully. Avoid using sharp objects that may puncture the can.
  • Test spray on a small inconspicuous area to ensure surface compatibility and finish suitability.

SPRAYING

  • Select the nozzle setting: The the nozzle setting, turn the red section on the nozzle.
  • Hold the can upright approximately 25cm from the surface.
  • Press button firmly and spray several light coats with a smooth sweeping motion, overlapping each spray pass. To prevent paint from sagging, avoid spraying too close to the surface or applying a heavy coat.
  • Repeat if necessary.

Do not use when air or surface temperature is below 15°C or above 30°C or in excessive humidity.

3. COVERAGE

Approximately 1.5m² per can, depending on the nature of the surface and amount of overspray.

4. DRYING

Touch dry in 15 minutes. Re-coat after 1 hour. Drying will be slower in cold or humid conditions, in the absence of ventilation or where heavy film builds are applied. Hard dry conditions can be achieved when the coated article is heated.

5. CLEAN UP

Overspray can be removed while still wet with mineral turps.To clean the nozzle after use and prevent blocking turn the can upside down and press button until only gas escapes.

6. SAFETY & FIRST AID

KEEP OUT OF REACH OF CHILDREN.

  • If swallowed, drink plenty of water and seek medical advice immediately. Do not induce vomiting.
  • If in eyes, immediately flush with running water for at least 15 minutes. Seek immediate medical attention.
  • Avoid breathing vapour or mist.
  • Use only with adequate ventilation.
  • If on skin, remove contaminated clothing. Wash skin thoroughly with soap and water. Do not use solvents or thinners.
  • Warning - Misuse by concentrating and inhaling contents can be harmful or fatal.

For 24 hour medical emergency response in Australia call 1800 883 254 and in New Zealand call 0800 000 096

7. CAUTION

EXTREMELY FLAMMABLE. Keep can away from flame and heat and eliminate any source of ignition. Keep can in a cool place and out of sun. Contents of can under pressure. Do not puncture or incinerate the can, even when empty.


Colour Range

Colours
White
Aluminium
Black
Metallic Charcoal
Due to colour variations in all browser types, the displayed colour palettes are a representation only of the actual colour. This should not be used in deciding the colour range suitable for you application.

Need Help?

It’s as easy as selecting a project type and the material involved