All Purpose Primer

White Knight Rust Guard All Purpose Primer may be applied to steel, wrought iron, timber and masonry.

• KEEP OUT OF REACH OF CHILDREN.
• If swallowed, seek medical advice immediately and show container or label. Do not induce vomiting.
• If in eyes, immediately flush with running water for at least 15 minutes. Seek immediate medical attention.
• Avoid breathing vapour or mist.
• Warning - Misuse by concentrating and inhaling contents can be harmful or fatal.
• Use only with adequate ventilation.
• If on skin, remove contaminated clothing. Wash skin thoroughly with soap and water.24 hour medicalemergency

For 24 hour medical emergency response in Australia call 1800 807 001 and in New Zealand call 0800 154 666

HIGHLY FLAMMABLE. KEEP AWAY FROM FLAME AND ELIMINATE ANY SOURCE OF IGNITION. Keep in a cool place and out of sun. Contents under pressure. Do not puncture or incinerate this can, even when empty.

1. Do not pour unwanted paint down the drain.
2. Keep unwanted paint in sealed containers for disposal via chemical waste collections.
3. Empty paint containers should be left open in a well ventillated area to dry out. When dry, recycle steel containers via steel recycling programs.
4. Residual paint should be sprayed onto newspaper, allowed to dry and then disposed of via domestic waste collections.
5. Empty aerosol cans are recyclable via can recycling programs.

1. The surface must be clean, dry and free from dust, dirt, grease, oil, rust scale and other contaminants.
2. Sand previously painted or glossy surfaces with #600 abrasive paper.
3. Cover surrounding areas to protect from overspray.
4. Test spray first on a small inconspicuous area to ensure surface compatibility.

1. Shake can vigorously for 1 minute before use and regularly during use.
2. Hold the can upright approximately 15-20 cm from the surface.
3. Press button firmly and spray with a smooth sweeping motion. Apply a pre-wetting mist coat followed by a full even coat, overlapping each spray pass. To prevent paint sagging, avoid spraying too close to the surface or spraying too heavily.
4. Repeat if necessary. 2 coats are required if applying a water based topcoat.

Do not use when air or surface temperature is below 15°C or above 30°C.

Overcoat when dry with an enamel (White Knight Rust Guard Epoxy Enamel, Hammered Finish) or water based (White Knight Rust Guard Advantage) topcoat.

Approximately 1.5m² per can

Touch dry in 10 minutes. Re-coat after 1 hour.

Drying will be slower in cold or humid conditions, in the absence of ventilation or where heavy film builds are applied. 

To prevent nozzle blocking, after use turn can upside down and press button until only gas escapes.

Overspray can be removed while still wet with White Knight Rust Guard Solvent or mineral turps.