Preparation

The surface must be clean, dry and free from dust, dirt, grease, oil and other contaminants. Remove all loose and flaking paint. Thoroughly sand glossy or enamel surfaces. Fill nail holes and cracks with appropriate filler and sand smooth. Treat any mould with suitable anti-mould solution. White Knight Glow Safe can be applied over any background colour, however a white background will provide the brightest glow.

Bare Concrete: Apply one coat of White Knight Ultra Pave White as per label directions.

Timber, Galvanised Iron and Previously Painted Surfaces: Prepare surface as detailed above. Apply one coat of Taubmans 3-in-1 Primer Sealer Undercoat. For other surfaces use an appropriate primer undercoat.

Heavy Floor Traffic Areas: Top-coat with White Knight Concrete Sealer or Floor Coat Plus.

Application Details

White Knight Glow Safe may be applied by brush or roller. Stir thoroughly with a broad, flat stirrer in a circular lifting motion for at least 5 minutes before use. Apply 1 to 3 coats with a heavy roller or brush depending on Glow time required. See Glow Time Reference. Apply a third coat for maximum glow time. Do not use when the air or surface temperature is below 10°C or above 35°C or when the humidity is very high.

DRY TIME Touch dry in 30 minutes. Re-coat after 2 hours. Drying will be slower in cold or humid conditions, in the absence of ventilation or where heavy film builds are applied. For heavy traffic areas, allow to dry overnight before top-coating with White Knight Concrete Sealer or Floor Coat Plus.

Glow Time Reference * :

Number of coats / Film Thickness (microns) / Glow Time (hours)

By Brush or Roller

One Coat /75 - 100 / 5 hrs.

Two Coats / 140 - 160 / >8hrs.

Three Coats / 175 - 200 / >10hrs.

*Based upon 3-4 hours of light absorption

Coverage

Clean Up

Health and Safety

Do not pour leftover paint down the drain. Unwanted paint should be brushed out on newspaper, allowed to dry and then disposed of via domestic waste collections.