Suitable Surfaces

Preparation

The surface must be clean, dry and free from dirt, grease, oil, rust scale and other contaminants. Remove all loose and flaking paint. Thoroughly sand glossy or enamel surfaces with 600# wet n dry abrasive paper Clean and allow to dry before painting.To achieve extra brightness, it is recommended that a white base coat be applied first. Timber, masonry and bare ferrous metal should be primed with White Knight Super Primer before painting. For galvanised iron and other non-ferrous metal surfaces use White Knight SLS Etch Primer. Fluoro Colour may be overcoated with an acrylic clear to extend the life of the painted surface, some loss in colour brightness may occur as a result.

BEFORE SPRAYING
Cover all necessary areas to protect from overspray. It is essential to shake the can for at least one minute after mixing ball rattles to ensure product uniformity. Shake can occasionally during use. Remove the cap

carefully. Avoid using sharp objectswhich may puncture the can.

Application Details

Do not use when the air or surface temperature is below 15°C or above 30°C or in excessive humidity.

Aerosol: Spray outside or in a well ventilated area away from fire and heaters. Test spray first on a small inconspicuous area to ensure surface compatibility and finish suitability. Hold the can upright approximately 15-20 cm from the surface. Press button firmly. Spray with a smooth sweeping motion. Apply a pre-wetting mist coat followed by a full even coat. Overlap each spray pass. Repeat if necessary. To prevent paint sagging, avoid spraying too close to the surface or spraying too heavy a coat. Brush on: Mix thoroughly before use. Apply 2 coats by brush.

After Spraying: To clean the nozzle after use and prevent blocking, turn the can upside down and press button until only gas escapes.

Coverage

Drying Times

Clean Up

Pack Sizes

Health and Safety

HANDY HINT