Suitable Surfaces

Preparation

The surface must be thoroughly cleaned before applying White Knight Clear Guard. New shiny surfaces must be washed with minerals turps and allowed to dry. On worn surfaces remove all stains and marks with a conventional metal polish. Remove all residues by washing down with White Knight Rust Guard Solvent or mineral turps, allow to dry and remove any smears. Do not handle surface prior to applying White Knight Clear Guard.

BEFORE SPRAYING:Cover all necessary areas to protect from overspray. It is essential to shake the can for at least .one minute after mixing ball rattles to ensure product uniformity. Shake can occasionally during use. Do not use when the air or surface temperature is below 15°C or above 30°C or in excessive humidity.

Application Details

Brush on :Stir thoroughly before and occasionally during use. Apply two to three coats by brush or roller.

Aerosol: Spray outside or in a well ventilated area away from fire and heaters. Test spray first on a small inconspicuous area to ensure surface compatibility and finish suitability. Hold the can upright approximately 15-20 cm from the surface. Press button firmly. Spray with a smooth sweeping motion. Apply a pre-wetting mist coat followed by a full even coat. Overlap each spray pass. Repeat if necessary. To prevent paint sagging, avoid spraying too close to the surface or spraying too heavy a coat.

Coverage

Brush On: Up to 14 square metres per litre depending on the nature of the surface.

Aerosol: Up to 1 to 1.5 square metres per unit depending on nature of the surface and the amount of overspray.

Drying Times

Clean Up

After Spraying

Pack Sizes

Re-Coat

Health and Safety

HANDY HINT